mac

IPv4 Multicast Protocol
394
1 to 25, default value is 1.
Command Mode: Global mode
Default: Enable the function.
Usage Guide: After enable vlan snooping in global mode, input this command to
configure the maximum query response time of the specific group.
Example: Configure/cancel the specific-query-mrsp of vlan3 as 2s.
Swith(config)#ip igmp snooping vlan 3 specific-query-mrsp 2
Swith(config)#no ip igmp snooping vlan 3 specific-query-mrspt
33.2.20 ip igmp snooping vlan static-group
Command: ip igmp snooping vlan <vlan-id> static-group <A.B.C.D> [source
<A.B.C.D>] interface [ethernet | port-channel] <IFNAME>
no ip igmp snooping vlan <vlan-id> static-group <A.B.C.D> [source
<A.B.C.D>]interface [ethernet | port-channel] <IFNAME>
Function: Configure static-group on specified port of the VLAN. The no form of the
command cancels this configuration.
Parameter: vlan-id: ranging between <1-4094>
A.B.C.D: the address of group or source
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode: Global mode
Default: No configuration by default.
Usage Guide: When a group is a static while also a dynamic group, it should be taken
as a static group. Deleting static group can only be realized by the no form of the
command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group 224.1.1.1 source 192.168.1.1
interface ethernet 1/1
33.2.21 ip igmp snooping vlan suppression-query-time
Command: ip igmp snooping vlan <vlan-id> suppression-query-time <value>
no ip igmp snooping vlan <vlan-id> suppression-query-time
Function: Configure the suppression query time. The “no ip igmp snooping vlan
<vlan-id> suppression-query-time” command restores to the default value.
Parameter: vlan-id: VLAN ID, ranging between <1-4094>