mac

Multicast Protocol
401
Example: Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface ethernet1/13
34.1.10 ipv6 mld snooping vlan mrouter-port learnpim6
Command: ipv6 mld snooping vlan <vlan-id> mrouter-port learnpim6
no ipv6 mld snooping vlan <vlan-id> mrouter-port learnpim6
Function: Enable the function that the specified VLAN learns mrouter-port (according to
pimv6 packets), the no command will disable the function.
Parameter: <vlan-id>: The specified VLAN ID, ranging from 1 to 4094.
Command Mode: Global Mode
Default: Enable
Usage Guide: Enable the function that the specified VLAN learns mrouter-port
(according to pimv6 packets). After a port received pimv6 packets, it will be set to
mrouter port for implementing the automatic learning.
Example: Disable the function that vlan 100 learns mrouter-port (according to pimv6
packets).
Switch(config)#no ipv6 mld snooping vlan 100 mrouter-port learnpim6
34.1.11 ipv6 mld snooping vlan mrpt
Command: ipv6 mld snooping vlan <vlan-id> mrpt <value>
no ipv6 mld snooping vlan <vlan-id> mrpt
Function: Configure the keep-alive time of the mrouter port.
Parameter: vlan-id: VLAN ID, the valid range is <1-4094>
value: mrouter port keep-alive time with a valid range of <1-65535> secs.
Command Mode: Global Mode
Default: 255s
Usage Guide: This configuration is applicable on dynamic mrouter port, but not on static
mrouter port. To use this command, MLD snooping must be enabled on the VLAN.
Example: Switch(config)#ipv6 mld snooping vlan 2 mrpt 100
34.1.12 ipv6 mld snooping vlan query-interval
Command: ipv6 mld snooping vlan <vlan-id> query-interval <value>
no ipv6 mld snooping vlan <vlan-id> query-interval
Function: Configure the query interval.
Parameter: vlan-id: VLAN ID, the valid range is <1-4094>
value: query interval, valid range: <1-65535>secs.
Command Mode: Global Mode