mac

Multicast Protocol
403
34.1.15 ipv6 mld snooping vlan static-group
Command: ipv6 mld snooping vlan<vlan-id> static-group <X:X::X:X> [source<
X:X::X:X>] interface [ethernet | port-channel] <IFNAME>
no ipv6 mld snooping vlan <vlan-id> static-group <X:X::X:X>
[source< X:X::X:X>] interface [ethernet | port-channel] <IFNAME>
Function: Configure static-group on specified port of the VLAN. The no form of the
command cancels this configuration.
Parameter: vlan-id: ranging between <1-4094>
X:X::X:X:The address of group or source.
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode: Global mode
Default: No configuration by default.
Usage Guide: When a group is a static while also a dynamic group, it should be taken
as a static group. Deleting static group can only be realized by the no form of the
command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group ff1e::15 source 2000::1 interface
ethernet 1/1
34.1.16 ipv6 mld snooping vlan
suppression-query-time
Command: ipv6 mld snooping vlan <vlan-id> suppression-query-time <value>
no ipv6 mld snooping vlan <vlan-id> suppression-query-time
Function: Configure the suppression query time; the “no” form of this command restores
the default value.
Parameter: vlan-id: VLAN ID, valid range: <1-4094>
value: valid range: <1-65535>secs.
Command Mode: Global Mode
Default: 255s
Usage Guide: This command can only be configured on L2 general querier. The
Suppression-query-time represents the period the suppression state maintains when
general querier receives queries from layer 3 MLD within the segment. To use this
command, the query-intervals in different switches within the same segment must be in
accordance. It is recommended to use the default value.