mac

Commands for Basic Switch Configuration

no privilege mode level <1-15> LINE

Function: Configure the level for the specified command, the no command restores the

original level of the command.

Parameters: mode: register mode of the command, ‘Tab’ or ‘?’ is able to show all

<1-15> is the level, its range between 1 and 15

LINE: the command needs to be configured, it supports the command

abbreviation

Command Mode: Global mode

Usage Guide: This function cannot change the command itself. LINE must be the whole

command format, the command with the abbreviation format must be analyzed

successfully. For half-baked command, false command about writing and command that

abbreviation cannot be analyzed successfully, the configuration is failure. For changing

the command line with the parameter, it should fill in the parameter which is able to be

selected discretionarily according to the required format. However, level of the no

command is able to be set optionally and it does not affect the result. When using no

command, LINE must be the configured command line. If the command line with the

parameter, the parameter must be matched with the configured command.

Example: Change the level of show ip route command to level 5.

Switch(config)#privilege exec level 5 show ip route

Change the level of peer A.B.C.D command to level 6.

Switch(config)#privilege router-msdp level 6 peer 1.2.3.4

Restore the original level for show ip route command.

Switch(config)#no privilege exec level 5 show ip route

Restore the original level for peer A.B.C.D command.

Switch(config)#no privilege router-msdp level 6 peer 1.2.3.4

1.1.23 reload

Command: reload

Function: Warm reset the switch.

Command mode: Admin Mode.

Usage Guide: The user can use this command to restart the switch without power off.

1.1.24 service password-encryption

Command: service password-encryption

no service password-encryption

Function: Encrypt system password. The “no service password-encryption”