mac

Commands for 802.1x
444
38.12 dot1x max-req
Command: dot1x max-req <count>
no dot1x max-req
Function: Sets the number of EAP request/MD5 frame to be sent before the switch
re-initials authentication on no supplicant response; the “no dot1x max-req” command
restores the default setting.
Parameters: <count> is the times to re-transfer EAP request/ MD5 frames, the valid
range is 1 to 10.
Command mode: Global Mode.
Default: The default maximum for retransmission is 2.
Usage Guide: The default value is recommended in setting the EAP request/ MD5
retransmission times.
Example: Changing the maximum retransmission times for EAP request/ MD5 frames to
5 times.
Switch(config)#dot1x max-req 5
38.13 dot1x user allow-movement
Command: dot1x user allow-movement
no dot1x user allow-movement
Function: Enable the authentication function after the user moves the port, the no
command disables the function.
Command Mode: Global mode
Default: Disable the authentication function after the user moves the port.
Usage Guide: Enable the authentication function after the user moves the port, so the
switch allows user to process this authentication. In the condition that the switch
connects with hub, when the user will be moved to other port, dot1x user
allow-movement command should be enabled.
Example: Enable the authentication function after the user moves the port.
Switch(config)#dot1x user allow-movement
38.14 dot1x user free-resource
Command: dot1x user free-resource <prefix> <mask>
no dot1x user free-resource
Function: To configure 802.1x free resource; the no form command closes this function.