mac

Commands for 802.1x
451
seconds; the valid range is 1 to 65535.
Command mode: Global Mode.
Default: The default value is 30 seconds.
Usage Guide: Default value is recommended.
Example: Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(config)#dot1x timeout tx-period 1200
38.27 dot1x unicast enable
Command: dot1x unicast enable
no dot1x unicast enable
Function: Enable the 802.1x unicast passthrough function of switch; the no operation of
this command will disable this function.
Command mode: Global Configuration Mode.
Default: The 802.1x unicast passthrough function is not enabled in global mode.
Usage Guide: The 802.1x unicast passthrough authentication for the switch must be
enabled first to enable the 802.1x unicast passthrough function, then the 802.1x function
is configured.
Example: Enabling the 802.1x unicast passthrough function of the switch and enable the
802.1x for port 1/1.
Switch(config)#dot1x enable
Switch(config)# dot1x unicast enable
Switch(config)#interface ethernet1/1
Switch(Config-If-Ethernet1/1)#dot1x enable
38.28 dot1x web authentication enable
This command is not supported by switch.
38.29 dot1x web authentication ipv6 passthrough
This command is not supported by switch.
38.30 dot1x web redirect
This command is not supported by switch.