mac

Commands for the Number Limitation Function of MAC in Port
455
Chapter 39 Commands for the Number
Limitation Function of MAC in Port
39.1 debug switchport mac count
Command: debug switchport mac count
no debug switchport mac count
Function: When the number limitation function debug of MAC on the port, if the number
of dynamic MAC and the number of MAC on the port is larger than the max number
allowed, users will see debug information. ”no debug switchport mac count” command
is used to disable the number limitation function debug of MAC on the port.
Parameters: None
Command Mode: Admin Mode
Default Settings: None
Usage Guide: Display the debug information of the number of dynamic MAC on the port.
Examples:
Switch#debug switchport mac count
%Jun 14 16:04:40 2007 Current mac count 21 is more than or equal to the maximum
limit in port Ethernet3/1
!!%Jun 14 16:04:40 2007 Mac learning will be stopped and some mac will be delete !!
39.2 debug vlan mac count
This command is not supported by switch.
39.3 mac-address query timeout
This command is not supported by switch.
39.4 show mac-address dynamic count
Command: show mac-address dynamic count { (vlan <1-4096>)| interface ethernet
<portName>}
Function: Display the number of dynamic MAC of corresponding port.