mac

Commands for AM Configuration
458
Chapter 40 Commands for AM
Configuration
40.1 am enable
Command: am enable
no am enable
Function: Globally enable/disable AM function.
Parameters: None.
Default: AM function is disabled by default.
Command Mode: Global Mode.
Usage Guide: None.
Example: Enable AM function on the switch.
Switch(config)#am enable
Disable AM function on the switch.
Switch(config)#no am enable
40.2 am port
Command: am iport
no am port
Function: Enable/disable AM function on port.
Parameters: None.
Default: AM function is disabled on all port.
Command Mode: Port Mode.
Example: Enable AM function on interface 1/3 of the switch.
Switch(Config-If-Ethernet 1/3)#am port
Disable AM function on interface 1/3 of the switch.
Switch(Config-If-Ethernet 1/3)#no am port
40.3 am ip-pool
Command: am ip-pool <ip-address> <num>