mac

Commands for RADIUS
471
command will disable that debug information.
Parameters: None.
Command Mode: Admin Mode.
Usage Guide: By enabling the debug information of aaa about events, users can check
the information of all kinds of event generated in the operation process of Radius
protocol, which might help diagnose the cause of faults if there is any.
Example: Enable the debug information of aaa about events.
Switch#debug aaa detail event
43.8 debug aaa error
Command: debug aaa error
no debug error
Function: Enable the debug information of aaa about errors; the no operation of this
command will disable that debug information.
Parameters: None.
Command Mode: Admin Mode.
Usage Guide: By enabling the debug information of aaa about errors, users can check
the information of all kinds of errors that occurs in the operation process of Radius
protocol, which might help diagnose the cause of faults if there is any.
Example: Enable the debug information of aaa about errors.
Switch#debug aaa error
43.9 radius nas-ipv4
Command: radius nas-ipv4 <ip-address>
no radius nas-ipv4
Function: Configure the source IP address for RADIUS packet sent by the switch. The
“no radius nas-ipv4” command deletes the configuration.
Parameter: <ip-address> is the source IP address of the RADIUS packet, in dotted
decimal notation, it must be a valid unicast IP address.
Default: No specific source IP address for RADIUS packet is configured, the IP address
of the interface from which the RADIUS packets are sent is used as source IP address of
RADIUS packet.
Command mode: Global Mode.
Usage guide: The source IP address must belongs to one of the IP interface of the
switch, otherwise an failure message of binding IP address will be returned when the