mac

Commands for Basic Switch Configuration
47
1.1.33 show memory usage
Command: show memory usage [<slotno>]
Function: Show memory usage rate.
Command mode: Admin and configuration mode.
Usage Guide: Check the current usage of memory resource by show memory usage
command. Only the chassis switch uses slotno parameter which is used to show the
memory usage rate of card on the specified slot, if there is no parameter, the default is
current card.
Example: Show the current usage rate of the memory.
Switch#show memory usage
The memory total 128 MB, free 58914872 bytes, usage is 56.10%
1.1.34 show privilege
Command: show privilege
Function: Show privilege of the current users.
Parameter: None.
Command Mode: All configuration modes
Example: Show privilege of the current user.
Switch(Config)#show privilege
Current privilege level is 15
1.1.35 show privilege mode LINE
Command: show privilege mode LINE
Function: Show the level of the specified command.
Parameters: mode: register mode of the command, ‘Tab’ or ‘?’ is able to show all
register modes
LINE: the command needs to be configured, it supports the command
abbreviation
Command Mode: Admin and configuration mode
Usage Guide: LINE must be the whole command format, the abbreviation format is used
to the command which can be analyzed successfully. For half-baked command, false
command about writing and command that abbreviation cannot be analyzed successfully,
the level of them cannot be shown.
Example: Show the level of privilege command.
Switch(config)#show privilege exec show ip route
The command : show ip route