mac

Commands for MRPP
528
51.7 hello-timer
Command: hello-timer <timer>
no hello-timer
Function: Configure timer interval of Hello packet from primary node of MRPP ring, the
“no hello-timer” command restores timer interval of default.
Parameter: <timer> valid range is from 1 to 100s.
Command Mode: MRPP ring mode
Default: Default configuration timer interval is 1s.
Usage Guide: The primary node of MRPP ring continuously sends Hello packet on
configured Hello timer interval, if secondary port of primary node can receive this packet
in configured period; the whole loop is normal, otherwise fail. Transfer node of MRPP
ring doesn’t need this timer and configure.
Example: Configure hello-timer of MRPP ring 4000 to 3 seconds.
Switch(config)# mrpp ring 4000
Switch(mrpp-ring-4000)#hello-timer 3
51.8 mrpp eaps compatible
Command: mrpp eaps compatible
no mrpp eaps compatible
Function: Enable the compatible mode for EAPS, the no command disables the
compatible mode.
Parameter: None.
Command Mode: Global mode
Default: Disable the compatible function of EAPS.
Usage Guide: If the compatible function of EAPS needs to be configured, MRPP
protocol should be enabled firstly. When executing no mrpp eaps compatible
command, it should ensure that the switch has enabled MRPP protocol.
Example: Enable the compatible function of EAPS globally.
Switch(Config)#mrpp enable
Switch(Config)#mrpp eaps compatible