mac

Commands for ULPP
537
52.10 flush enable arp
Command: flush enable arp
Function: Enable sending the flush packets of deleting ARP.
Parameter: None.
Default: By default, enable sending the flush packets of deleting ARP.
Command mode: ULPP group configuration mode.
Usage Guide: If enable this function, when the link is switched, it will actively send the
flush packets to notify the upstream device, so as to delete the list entries of ARP.
Example: Enable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable arp
52.11 flush enable mac
Command: flush enable mac
Function: Enable sending the flush packets of updating MAC address.
Parameter: None.
Default: By default, enable sending the flush packets of updating MAC address.
Command mode: ULPP group configuration mode.
Usage Guide: If enable this function, when the link is switched, it will actively send the
flush packets to notify the upstream device, so as to update the MAC address table.
Example: Enable sending the flush packets of updating MAC address.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable mac
52.12 preemption delay
Command: preemption delay <integer>
no preemption delay
Function: Configure the preemption delay, the no command configures the preemption
delay as the default value.
Parameter: <integer>: the preemption delay, range from 1 to 600, in second.
Default: The default preemption delay is 30.
Command mode: ULPP group configuration mode.