mac

Commands for ULPP
541
correspond the existent VLAN, after it is configured, this VLAN can’t be deleted.
Example: Configure the receiving control VLAN as 10.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp control vlan 10
52.19 ulpp flush disable arp
Command: ulpp flush disable arp
Function: Disable receiving the flush packets of deleting ARP.
Parameter: None.
Default: By default, disable receiving the flush packets of deleting ARP.
Command mode: Port mode.
Usage Guide: If this command is configured, then it will not receive the flush packets of
deleting ARP.
Example: Disable receiving the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable arp
52.20 ulpp flush disable mac
Command: ulpp flush disable mac
Function: Disable receiving the flush packets of updating MAC address.
Parameter: None.
Default: By default, disable receiving the flush packets of updating MAC address.
Command mode: Port mode.
Usage Guide: If this command is configured, then it will not receive the flush packets of
updating MAC address.
Example: Disable receiving the flush packets of updating MAC address.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable mac
52.21 ulpp flush enable arp
Command: ulpp flush enable arp
Function: Enable receiving the flush packets of deleting ARP.
Parameter: None.
Default: By default, disable receiving the flush packets of deleting ARP.