mac

Commands for ULPP
542
Command mode: Port mode.
Usage Guide: Enable this function to receive the flush packets which delete ARP.
Example: Enable receiving of the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush enable arp
52.22 ulpp flush enable mac
Command: ulpp flush enable mac
Function: Enable receiving the flush packets of updating MAC address.
Parameter: None.
Default: By default, disable receiving the flush packets of updating MAC address.
Command mode: Port mode.
Usage Guide: Enable receiving the flush packets of updating MAC address table.
Example: Enable receiving the flush packets of updating the MAC address.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush enable mac
52.23 ulpp group
Command: ulpp group <integer>
no ulpp group <integer>
Function: Create a ULPP group. If this group exists, then enter the configuration mode
of ULPP group. The no command deletes a ULPP group.
Parameter: <integer> is the ID of ULPP group, range from 1 to 48.
Command mode: Global Mode.
Default: Any ULPP groups are not configured.
Usage Guide: None.
Example: Configure ulpp group 20 or enter the mode of ulpp group 20.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)#
52.24 ulpp group master
Command: ulpp group <integer> master
no ulpp group <integer> master
Function: Configure the master port of ULPP group, the no command deletes the