mac

Commands for Reload Switch after Specified Time
585
Chapter 60 Commands for Reload
Switch after Specified Time
60.1 reload after
Command: reload after {[<HH:MM:SS>] [days <days>]}
Function: Reload the switch after a specified period of time.
Parameters: <HH:MM:SS> the specified time, HH (hours) ranges from 0 to 23, MM
(minutes) and SS (seconds) range from 0 to 59.
<days> the specified days, unit is day, range from 1 to 30.
time and day may be configured at the same time or configured solely.
Command Mode: Admin mode
Usage Guide: With this command, users can reboot the switch without shutdown its
power after a specified period of time, usually when updating the switch version. The
switch can be rebooted after a period of time instead of immediately after its version
being updated successfully. This command will not be reserved, which means that it only
has one-time effect. After this command is configured, it will prompt the reboot
information when user logging in the switch by telnet.
Example: Set the switch to automatically reload after 2 days, 10 hours and 1 second.
Switch#reload after 10:00:01 days 2
Process with reboot after? [Y/N] y
Related Commands: reload, reload cancel, show reload
60.2 reload cancel
Command: reload cancel
Function: Cancel the specified time period to reload the switch.
Parameters: None
Command Mode: Admin mode.
Usage Guide: With this command, users can cancel the specified time period to reload
the switch, that is, to cancel the configuration of command “reload after”. This command
will not be reserved.
Example: Prevent the switch to automatically reboot after the specified time.
Switch#reload cancel