mac

Commands for Cluster
86
10.254.254.10
Switch(config)#cluster ip-pool 10.254.254.10
2.5 cluster keepalive interval
Command: cluster keepalive interval <second>
no cluster keepalive interval
Function: Configure the interval of keepalive messages within the cluster.
Parameters: <second>: keepalive interval, in seconds, ranging from 3 to 30.
Default: The default value is 30 seconds.
Command Mode: Global Configuration Mode.
Usage Guide: After executing this command on a commander switch, the value of the
parameter will be distributed to all member switches via the TCP connections between
the commander and members.
After executing it on a non commander switch, the configuration value will be saved
but not used until the switch becomes a commander. Before that, its keepalive interval is
the one distributed by its commander.
Commander will send DP messages within the cluster once in every keepalive
interval. Members will respond to the received DP messages with DR messages.
The no operation of this command will restore the keepalive interval in the cluster
back to its default value.
Example: Set the keepalive interval in the cluster to 10 seconds.
Switch(config)#cluster keepalive interval 10
2.6 cluster keepalive loss-count
Command: cluster keepalive loss-count<loss-count>
no cluster keepalive loss-count
Function: Configure the max number of lost keepalive messages in a cluster that can be
tolerated.
Parameters: loss-count: the tolerable max number of lost messages, ranging from 1 to
10.
Default: The default value is 3.
Command Mode: Global Configuration Mode
Usage Guide: After executing this command on a commander switch, the value of the
parameter will be distributed to all member switches via the TCP connections between
the commander and members.