mac

Commands for Cluster
95
Upstream remote-port:eth 1/2
Upstream speed: 100full
Switch#
----------------------------------------------
Switch#show cluster topology mac-address 01-02-03-04-05-02
Toplogy role: Member
Member status: Active member (user-config)
SN: 2
MAC Address: 01-02-03-04-05-02
Description: ES4626H
Hostname : LAB_SWITCH_2
Upstream local-port: eth 1/1
Upstream node: 01-02-03-04-05-01
Upstream remote-port: eth 1/2
Upstream speed: 100full
2.18 rcommand commander
Command: rcommand commander
Function: In the member switch, use this command to configure the commander switch.
Parameter: None.
Default: None.
Command mode: Admin Mode.
Instructions: This command is used to configure the commander switch remotely.
Users have to telnet the commander switch by passing the authentication. The
command “exit” is used to quit the configuration interface of the commander switch. This
command can only be executed on member switches.
Example: In the member switch, enter the configuration interface of the commander
switch.
Switch#rcommand commander
2.19 rcommand member
Command: rcommand member <mem-id>
Function: In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter: <mem-id> commander the member id allocated by commander to each