mac

107
Usage Guide: This command can be used to display the information about state
transitions of the specified interfaces.
Example: Print the information about state transitions of interface ethernet 1/1.
Switch#debug uldp fsm interface ethernet 1/1
3.4.4 debug uldp interface ethernet
Command: debug uldp {hello|probe|echo|unidir|all} [receive|send] interface
ethernet <IFname>
no debug uldp {hello|probe|echo|unidir|all} [receive|send] interface
ethernet <IFname>
Function: Enable the debug function of display the packet details. After that, display
some kinds of the packet details of terminal interface.
Parameter: <IFname>: Name of the interface.
Command mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display the Hello packet details receiving on the
interface Ethernet 1/1.
Switch#debug uldp hello receive interface Ethernet 1/1
3.4.5 debug uldp packet
Command: debug uldp packet [receive|send]
no debug uldp packet [receive|send]
Function: Enable receives and sends packet debug function, after that. Display the type
and interface of the packet which receiving and sending on the client. The no form
command disables this function.
Parameter: None.
Command mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display the packet that receiving on each interface.
Switch#debug uldp packet receive
3.4.6 uldp aggressive-mode
Command: uldp aggressive-mode
no uldp aggressive-mode
Function: To configure ULDP to work in aggressive mode. The no form of this command