mac

121
initial user configuration will not be restored. If it is configuration for modules, such as
shutdown configuration, then the configuration to current port will apply to all member
ports in the corresponding port group.
Example: Entering configuration mode for port-channel 1.
Switch(config)#interface port-channel 1
Switch(Config-If-Port-Channel1)#
3.6.3 lacp port-priority
Command: lacp port-priority <port-priority>
no lacp port-priority
Function: Set the port priority of LACP protocol.
Parameters: <port-priority>: the port priority of LACP protocol, the range from 0 to 65535.
Command mode: Port Mode.
Default: The default priority is 32768 by system.
Usage Guide: Use this command to modify the port priority of LACP protocol, the no
command restores the default value.
Example: Set the port priority of LACP protocol.
Switch(Config-If-Ethernet1/1)# lacp port-priority 30000
3.6.4 lacp system-priority
Command: lacp system-priority <system-priority>
no lacp system-priority
Function: Set the system priority of LACP protocol.
Parameters: <system-priority>: The system priority of LACP protocol, ranging from 0 to
65535.
Command mode: Global Mode
Default: The default priority is 32768.
Usage Guide: Use this command to modify the system priority of LACP protocol, the no
command restores the default value.
Example: Set the system priority of LACP protocol.
Switch(config)#lacp system-priority 30000
3.6.5 lacp timeout
Command: lacp timeout {short | long}
no lacp timeout