mac

126
3.7 Commands for Jumbo
3.7.1 jumbo enable
Command: jumbo enable [<mtu-value>]
no jumbo enable
Function: Configure the MTU size of JUMBO frame, enable the jumbo receiving/sending
function. The no command restores to the normal frame receiving function.
Parameter: mtu-value: the MTU value of jumbo frame that can be received, in byte,
ranging from <1500-9000>. The corresponding frame size is <1518/1522-9018/9022>.
Without setting is parameter, the allowed max frame size is 9018/9022.
Default: Jumbo function not enabled by default.
Command mode: Global Mode
Usage Guide: Set switch of both ends jumbo necessarily, or jumbo frame will be dropped
at the switch has not be set. Notice: Set the MTU value of JUMBO frame are 1500, 1518,
1982, 2030 bytes for this device only.
Example: Enable the jumbo function of the switch.
Switch(config)#jumbo enable