mac

131
Flags field is 1. Note that the high threshold can not be less than the low threshold.
Example: Configure the high threshold of errored frame period event on port 1/4 to 3000.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame-period threshold high 3000
3.8.11 ethernet-oam errored-frame-period threshold
low
Command: ethernet-oam errored-frame-period threshold low <low-frames>
no ethernet-oam errored-frame-period threshold low
Function: Configure the low threshold of errored frame period event, no command
restores the default value.
Parameters: <low-frames>, the low detection threshold of errored frame period event,
ranging from 1 to 4294967295 frames.
Command mode: Port mode
Default: 1.
Usage Guide: During the specific detection period, errored frame period event is induced
if the number of errored frame is larger than or equal to the low threshold and the device
notifies the peer by event notification OAMPDU. Note that the low threshold should not be
larger than the high threshold.
Example: Configure the low threshold of errored frame period event on port 1/4 to 100.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-frame-period threshold low 100
3.8.12 ethernet-oam errored-frame-period window
Command: ethernet-oam errored-frame-period window <seconds>
no ethernet-oam errored-frame-period window
Function: Configure the detection period of errored frame period event, no command
restores the default value.
Parameters: <seconds>, the detection period value of errored frame period event,
ranging from 1 to 60s.
Command mode: Port mode
Default: 1.
Usage Guide: Detect errored frame of the port after the time of specific detection period.
If the number of errored frame is larger than or equal to the threshold, corresponding
event is induced and the device notifies the peer through OAMPDU. When sending the
packets, the maximum number of frames is filled as the value of window in errored frame
period event. The conversion rule is maximum number of frames= interface bandwidth×