mac

152
no private-vlan association
Function: Set Private VLAN association; the no command cancels Private VLAN
association.
Parameter: <secondary-vlan-list> Sets Secondary VLAN list which is associated to
Primary VLAN. There are two types of Secondary VLAN: Isolated VLAN and Community
VLAN. Users can set multiple Secondary VLANs by ';'.
Command mode: VLAN Mode.
Default: There is no Private VLAN association by default.
Usage Guide: This command can only used for Private VLAN. The ports in Secondary
VLANs which are associated to Primary VLAN can communicate to the ports in Primary
VLAN.
Before setting Private VLAN association, three types of Private VLANs should have
no member ports; the Private VLAN with Private VLAN association can‘t be deleted. When
users delete Private VLAN association, all the member ports in the Private VLANs whose
association is deleted are removed from the Private VLANs.
Example: Associate Isolated VLAN200 and Community VLAN300 to Primary VLAN100.
Switch(Config-Vlan100)#private-vlan association 200;300
4.1.16 show dot1q-tunnel
Command: show dot1q-tunnel
Function: Display the information of all the ports at dot1q-tunnel state.
Parameter: None.
Command Mode: Admin and Configuration Mode.
Usage Guide: This command is used for displaying the information of the ports at
dot1q-tunnel state.
Example: Display current dot1q-tunnel state.
Switch#show dot1q-tunnel
Interface Ethernet1/1:
dot1q-tunnel is enable
Interface Ethernet1/3:
dot1q-tunnel is enable
4.1.17 show garp timer
Command: show garp timer (join | leave | leaveall |)
Function: Show the value of each timer. Note that the value is not the remaining time to
run the timer but the initial value when enabling the timer.