mac

169
Usage Guide: Display the configuration of Protocol-based VLAN on the switch.
Example: Display the configuration of the current Protocol-based VLAN.
Switch#show protocol-vlan
Protocol_Type VLAN_ID Priority
------------------- ------------- ---------
etype 0x800 200 4
etype 0x860 200 4
etype 0xabc 100 5
4.2.10 show subnet-vlan
This command is not supported by this switch.
4.2.11 show subnet-vlan interface
This command is not supported by this switch.
4.2.12 subnet-vlan
This command is not supported by this switch.
4.2.13 switchport mac-vlan enable
Command: switchport mac-vlan enable
no switchport mac-vlan enable
Function: Enable the MAC-based VLAN function on the port; the no form of this
command will disable the MAC-based VLAN function on the port.
Parameter: None.
Command Mode: Port Mode.
Default: The MAC-base VLAN function is enabled on the port by default.
Usage Guide: After adding a MAC address to specified VLAN, the MAC-based VLAN
function will be globally enabled. This command can disable the MAC-based VLAN
function on specified port to meet special user applications.
Example: Disable the MAC-based VLAN function on port1.
Switch#config
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#no switchport mac-vlan enable
4.2.14 switchport subnet-vlan enable