mac

222
Apply policy-map p1 (p1 corresponds with the action that modify c-vid) to Ethernet port 1/1
for flexible QinQ.
Switch(Config-If-Ethernet1/1)#service-policy p1 in
9.5 set
Command: set {s-vid <new-vid> | c-vid <new-vid>}
no set {s-vid | c-vid}
Function: Assign the new cos and vid value to the packets which match the class map, no
command cancels the operation.
Parameters: s-vid <new-vid> specifies VID of an external VLAN Tag
c-vid <new-vid> specifies VID of a inner VLAN Tag
Default: Do not assign the value.
Command Mode: Policy class-map configuration mode
Usage Guide: Only assign the new value again for the classified flow that correspond the
match standard.
Example: Set an external VLAN Tag' VID as 3 for the packet which satisfy c2 class rule.
Switch(config)#policy-map p1
Switch(Config-PolicyMap-p1)#class c2
Switch(Config-PolicyMap-p1-Class-c2)#set s-vid 3
Switch(Config-PolicyMap-p1-Class-c2)#exit
Chapter 10 Commands for Layer 3
Management
10.1 Commands for Layer 3 Interface
10.1.1 description
Command: description <text>
no description
Function: Configure the description information of VLAN interface. The no command will