mac

231
This command is not supported by the switch.
10.2.18 ipv6 nd max-ra-interval
This command is not supported by the switch.
10.2.19 ipv6 nd prefix
This command is not supported by the switch.
10.2.20 ipv6 nd other-config-flag
This command is not supported by the switch.
10.2.21 ipv6 nd managed-config-flag
This command is not supported by the switch.
10.2.22 ipv6 neighbor
Command: ipv6 neighbor <ipv6-address> <hardware-address> interface
<interface-type interface-name>
no ipv6 neighbor <ipv6-address>
Function: Set static neighbor table entry.
Parameters: Parameter ipv6-address is static neighbor IPv6 address, parameter
hardware-address is static neighbor hardware address, interface-type is Ethernet type,
interface-name is Layer 2 interface name.
Command Mode: Interface Configuration Mode
Default Situation: There is not static neighbor table entry.
Usage Guide: IPv6 address and multicast address for specific purpose and local address
can not be set as neighbor.
Example: Set static neighbor 2001:1:2::4 on port E1/1, and the hardware MAC address is
00-03-0f-89-44-bc.
Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-03-0f-89-44-bc interface Ethernet
1/1
10.2.23 show ip interface
Command: show ip interface [<ifname> | vlan <vlan-id>] brief