mac

410
no tacacs-server key
Function: Configure the key of TACACS+ authentication server; the ―no tacacs-server
key‖ command deletes the TACACS+ server key.
Parameter: <string> is the character string of the TACACS+ server key, containing
maximum 16 characters.
Command Mode: Global Mode
Usage Guide: The key is used on encrypted packet communication between the switch
and the TACACS+ server. The configured key must be in accordance with the one on the
TACACS+ server or else no correct TACACS+ authentication will be performed. It is
recommended to configure the authentication server key to ensure the data security.
Example: Configure test as the TACACS+ server authentication key.
Switch(config)#tacacs-server key test
29.3 tacacs-server nas-ipv4
Command: tacacs-server nas-ipv4 <ip-address>
no tacacs-server nas-ipv4
Function: Configure the source IP address of TACACS+ packet sent by the switch; the
―no tacacs-server nas-ipv4‖ command deletes the configuration.
Parameter: <ip-address> is the source IP address of TACACS+ packet, in dotted
decimal notation, it must be a valid unicast IP address.
Default: No specific source IP address for TACACS+ packet is configured, the IP address
of the interface from which the TACACS+ packets are sent is used as source IP address
of TACACS+ packet.
Command Mode: Global Mode
Usage Guide: The source IP address must belongs to one of the IP interface of the switch,
otherwise an failure message of binding IP address will be returned when the switch send
TACACS+ packet. We suggest using the IP address of loopback interface as source IP
address, it avoids that the packets from TACACS+ server are dropped when the interface
link-down.
Example: Configure the source ip address of TACACS+ packet as 192.168.2.254.
Switch#tacacs-server nas-ipv4 192.168.2.254
29.4 tacacs-server timeout
Command: tacacs-server timeout <seconds>
no tacacs-server timeout