mac

469
38.9 mrpp ring
Command: mrpp ring <ring-id>
no mrpp ring <ring-id>
Function: Create MRPP ring, and access MRPP ring mode, the ―no mrpp ring<ring-id>‖
command deletes configured MRPP ring.
Parameter: <ring-id> is MRPP ring ID, the valid range is from 1 to 4096.
Command Mode: Global Mode
Usage Guide: If this MRPP ring doesn‘t exist it create new MRPP ring when executing
the command, and then it enter MRPP ring mode. It needs to ensure disable this MRPP
ring when executing the ―no mrpp ring‖ command.
Example:
Switch(config)#mrpp ring 100
38.10 mrpp ring primary-port
Command: mrpp ring <ring-id> primary-port
no mrpp ring <ring-id> primary-port
Function: Specify MRPP ring primary-port.
Parameter: <ring-id> is the ID of MRPP ring; range is <1-4096>.
Command Mode: Port mode
Default: None
Usage Guide: The command specifies MRPP ring primary port. Primary node uses
primary port to send Hello packet, secondary port is used to receive Hello packet from
primary node. There are no difference on function between primary port and secondary of
secondary node.
The mrpp enable command must be enabled before the control-vlan command be
used. If primary port, secondary port, node-mode and enable commands all be configured
after control-vlan, then the mrpp-ring function is enabled.
Example: Configure the primary of MRPP ring 4000 to Ethernet 1/1.
Switch(Config)#interface ethernet 1/1
Switch(config-If-Ethernet1/1)#mrpp ring 4000 primary-port