Manualshelf

mac

ManualsBrandsip ManualsNetworkingipv6
471472473474475476477478479480
480
39.19 ulpp flush disable arp
Command: ulpp flush disable arp
Function: Disable receiving the flush packets of deleting ARP.
Parameter: None.
Default: By default, disable receiving the flush packets of deleting ARP.
Command mode: Port mode.
Usage Guide: If this command is configured, then it will not receive the flush packets of
deleting ARP.
Example: Disable receiving the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable arp
39.20 ulpp flush disable mac
Command: ulpp flush disable mac
Function: Disable receiving the flush packets of updating MAC address.
Parameter: None.
Default: By default, disable receiving the flush packets of updating MAC address.
Command mode: Port mode.
Usage Guide: If this command is configured, then it will not receive the flush packets of
updating MAC address.
Example: Disable receiving the flush packets of updating MAC address.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable mac
39.21 ulpp flush enable arp
Command: ulpp flush enable arp
Function: Enable receiving the flush packets of deleting ARP.
Parameter: None.
Default: By default, disable receiving the flush packets of deleting ARP.
Command mode: Port mode.
Usage Guide: Enable this function to receive the flush packets which delete ARP.
Example: Enable receiving of the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1