mac

490
Default: The destination port of the sFlow packet is defaulted at 6343, and the analyzer
has no default address.
Usage Guide: If the analyzer address is configured at Port Mode, this IP address and port
configured at Port Mode will be applied when sending the sample packet. Or else the
address and port configured at global mode will be applied. The analyzer address should
be configured to let the sFlow sample proxy work properly.
Example: Configure the analyzer address and port at global mode.
switch (config)#sflow destination 192.168.1.200 1025
42.6 sflow header-len
Command: sflow header-len <length-value>
no sflow header-len
Function: Configure the length of the head data packet copied in the sFlow data sampling.
The ―no‖ form of this command restores the default value.
Parameter: <length-value> is the value of the length with a valid range of 32-256.
Command Mode: Port Mode.
Default: 128 by default.
Usage Guide: If the packet sample can not be identified whether it is IPv4 or IPv6 when
sent to the CPU, certain length of the head of the group has to be copied to the sFlow
packet and sent out. The length of the copied content is configured by this command.
Example: Configure the length of the packet data head copied in the sFlow data sampling
to 50.
Switch(Config-If-Ethernet1/2)#sflow header-len 50
42.7 sflow priority
Command: sflow priority <priority-value>
no sflow priority
Function: Configure the priority when sFlow receives packet from the hardware. The "no‖
form of the command restores the default.
Parameter: <priority-value> is the priority value with a valid range of 0-3.
Command Mode: Global Mode.
Default: The default value is 0.
Usage Guide: When sample packet is sent to the CPU, it is recommended not to assign
high priority for the packet so that regular receiving and sending of other protocol packet