mac

500
44.12 ntp disable
Command: ntp disable
no ntp disable
Function: To disable/enable the NTP function on port.
Parameter: None.
Default: To enable NTP function on all ports.
Command Mode: Interface Configuration Mode.
Usage Guide: None.
Example: To disable the NTP function on vlan1 interface.
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)#ntp disable
44.13 ntp enable
Command: ntp enable
ntp disable
Function: To enable/disable NTP function globally.
Parameter: None.
Default: Disabled.
Command Mode: Global Mode.
Usage Guide: None.
Example: To enable NTP function.
Switch(config)#ntp enable
44.14 ntp ipv6 multicast client
This command is not supported by the switch.
44.15 ntp multicast client
This command is not supported by the switch.
44.16 ntp server
Command: ntp server {<ip-address> | <ipv6-address>} [version <version_no>] [key