mac

527
48.8 show cpu-rx protocol
Command: show cpu-rx protocol [ <protocol-type> ]
Function: Show the statistics of the CPU received packets of the specified protocol type.
Parameter: <protocol- type> is the protocol type of the packets, if do not input
parameters, show all statistic packets.
Command Mode: Admin and configuration mode
Default: None.
Usage Guide: This command is used to debug, it is supposed to be used with the help of
the technical support.
Example：Show the statistics of CPU receiving ARP packets.
Switch#show cpu-rx protocol arp
Type Rate-limit TotPkts CurState
arp 500 3 allowed
Chapter 49 Detailed information on
changes
 Added ―EFM OAM‖ operation and command.
 Deleted command ―ethernet-oam remote-loopback‖, ―ethernet-oam
remote-loopback supported‖, ―show ethernet-oam loopback status‖.
 Deleted ―EFM OAM‖ basic configuration.
 Enabled ―EFM OAM‖ port loopback configuration commands and appropriate
instructions.
 In the instruction to the command ―mac-address-table aging-time‖ phrase
―entry will be deleted‖ changed to ―entry will be aged‖.
 command ―show gvrp current (dynamic | static | ) registerd vlan interface
(Ethernet | port-channel |) IFNAME‖ changed to ―show gvrp port (dynamic |
static | ) registerd vlan interface (Ethernet | port-channel |) IFNAME‖
 command ―show gvrp vlan <1-4094> registerd ports‖ changed to ―show gvrp
vlan <1-4094> registerd port‖
 added ―mac-address-table trap enable‖ command, manual, appropriate
instructions on functions order and configuration.
 Changed example for ―show mls qos vlan‖.