mac

Example: Create a group CompanyGroup, with the safety level of recognizing

andencrypting, the read viewname isreadview, and the writing is disabled.

Switch (config)#snmp-server group CompanyGroup AuthPriv read readview

Delete group

Switch (config)#no snmp-server group CompanyGroup AuthPriv

1.4.17 snmp-server host

Command: snmp-server host { <host-ipv4-address> | <host-ipv6-address> } {v1 |

v2c | {v3 {NoauthNopriv | AuthNopriv | AuthPriv}}} <user-string>

no snmp-server host { <host-ipv4-address> | <host-ipv6-address> } {v1 |

v2c | {v3 {NoauthNopriv | AuthNopriv | AuthPriv}}} <user-string>

Function: As for the v1/v2c versions this command configures the IPv4 or IPv6 address

and Trap community character string of the network manage station receiving the SNMP

Trap message. And for v3 version, this command is used for receiving the network

manage station IPv4 or IPv6 address and the Trap user name and safety level; the ―no‖

form of this command cancels this IPv4 or IPv6 address.

Command Mode: Global Mode.

Parameter: <host-ipv4-addr> is IP address of NMS management station which receives

Trap message.

<host-ipv6-addr> is IPv6 address of NMS management station which

receives Trap message.

v1 | v2c | v3 is the version number when sending the trap.

NoauthNopriv | AuthNopriv | AuthPriv is the safety level v3 trap is applied,

which may be non encrypted and non authentication, non encrypted and

authentication, encrypted and authentication.

<user-string> is the community character string applied when sending the

Trap message at v1/v2, and will be the user name at v3.

Usage Guide: The Community character string configured in this command is the default

community string of the RMON event group. If the RMON event group has no community

character string configured, the community character string configured in this command

will be applied when sending the Trap of RMON, and if the community character string is

configured, its configuration will be applied when sending the RMON trap. This command

allows to configure IPv4 or IPv6 addresses of SNMP management station that receive

Trap message at the same time, but IPv4 and IPv6 addresses of v1 and v2c version are

less than 8 in all.

Example:

Configure an IP address to receive Trap