mac

86
Instructions: This command is used to configure the commander switch remotely. Users
have to telnet the commander switch by passing the authentication. The command ―exit‖
is used to quit the configuration interface of the commander switch. This command can
only be executed on member switches.
Example: In the member switch, enter the configuration interface of the commander
switch.
Switch#rcommand commander
2.19 rcommand member
Command: rcommand member <mem-id>
Function: In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter: <mem-id> commander the member id allocated by commander to each
member, whose range is 1～128.
Default: None.
Command mode: Admin Mode.
Usage Guide: After executing this command, users will remotely login to a member
switch and enter Admin Mode on the latter. Use exit to quit the configuration interface of
the member. Because of the use of internal private IP, telnet authentication will be omitted
on member switches. This command can only be executed on commander switches.
Example: In the commander switch, enter the configuration interface of the member
switch with member-id 1.
Switch#rcommand member 1
Chapter 3 Commands for Network Port
Configuration
3.1 Commands for Ethernet Port Configuration
3.1.1 bandwidth
Command: bandwidth control <bandwidth> {transmit | receive | both}
no bandwidth control