mac

94
Command mode: Interface Mode
Default: There is no control operation for rate-violation.
Usage Guide: This command is mainly used to detect the abnormal port flow. For
example, when there are a large number of broadcast messages caused by a loopback,
which affect the processing of other tasks, the port will be shut down to ensure the normal
processing of the switch.
Example: Set the rate-violation of port 8-10 (GB ports) of the switch as 10000pps and the
port recovery time as 1200 seconds.
Switch(config)#interface ethernet 1/8-10
Switch(Config-Port-Range)#rate-violation 10000 recovery 1200
3.1.14 rate-violation control
This command is not supported by the switch.
3.1.15 remote-statistics interval
This command is not supported by the switch.
3.1.16 show interface
Command: show interface [ethernet <interface-number> | port-channel
<port-channel-number> | vlan <vlan-id> | <interface-name>] [detail]
show interface ethernet status
show interface ethernet counter {packet | rate}
Function: Show information of layer 3 or layer 2 port on the switch
Parameter: <vlan-id> is the VLAN interface number, the value range from 1 to 4094.
<interface-number> is the port number of the Ethernet, status show important
information of all the layer 2 ports. counter {packet | rate} show package number or rate
statistics of all layer 2 ports. <port-channel-number> is the number of the aggregation
interface, <interface-name> is the name of the interface such as port-channel1. [detail]
show the detail of the port.
Command mode: Admin and Configuration Mode.
Default: Information not displayed by default
Usage Guide: While for vlan interfaces, the port MAC address, IP address and the
statistic state of the data packet will be shown; As for Ethernet port, this command will
show port speed rate, duplex mode, flow control switch state, broadcast storm
suppression of the port and the statistic state of the data packets; for aggregated port, port