User Manual

7.1 GENERAL DATA
Insert the SIM card. Make sure the contacts face the contact springs of the card holder
and the index corner is positioned correctly. Close the card holder again until the locking
bar snaps into place.
Place the housing of the µCROS SL on the ESD mat and slide the heat sink/PCB assembly
into it until the leading edge of the heet sink contacts the housing. Be careful not to rip
the small EMC fingers at the side of the PCB from their sockets and check that the EMC
fingers on the side of the POWER/CAN/IO connector are inside the housing.
Changes and errors excepted. µCROS SL V1.10 EN - 2020/03 24