User Manual

7.1 GENERAL DATA
Retain the housing by placing your index fingers on the protituding tabs, put your thumbs
on the POWER/CAN/IO connector and push towards the heat sink until the heat sink/PCB
assembly drops into the housing. Some force will be needed to overcome the initial resis-
tance.
Attention:
Make sure to keep your fingers away from the gap between the housing
and the heat sink to avoid pinching your skin.
Flip the assembly and attach the screws. Use medium strength threadlocker (LOCTITE
243/248 or equivalent) to secure the screws in place. Tighten with 0.44 Nm torque.
7.1.4.3 BIOS battery replacement
Changes and errors excepted. µCROS SL V1.10 EN - 2020/03 25