User Manual

7.7 ELECTRICAL DATA
7.7.4 Digital Output
Type Voltage source
Output Voltage positive supply voltage UB+
Maximum continuous current 200 mA
Internal resistance approx. 6.5 Ω@25°C; < 9 Ω@75°C
7.7.5 GNSS
Position data for the system is provided by an u-blox NEO-M8N module which uses the GPS
satellite network to provide accurate position information.
7.7.6 LAN
The RJ45 port of the LAN interface supports a IEEE 802.3ab (aka. 1000BASE-T) gigabit eth-
ernet over UTP cat.5 cabling and accepts standard patch cables with a IEC 60603-7 8P8C
(”RJ45”) connectors.
7.7.7 m.2 Slot
The m.2 slot of the µCROS SL contains the SSD drive for the firmware and data storage.
Attention:
The µCROS SL needs an m.2 card complete with firmware and drivers
installed in the slot to work properly. Installation or removal of the m.2
card may be done by qualified service personnel only. Do not attempt to
replace the card without detailed instructions and a replacement card
with preinstalled firmware.
The m.2 connector mounted in the µCROS SL is keyed for slot ”B” and supports SATA 3
cards with a width of 22 mm and a length of 42 mm.
7.7.8 Supply
Supply Voltage 6 - 36 V DC
Power consumption
Operation 30 W max. with USB and digital output
Standby approx. 10 mW
Standby with WoC approx. 120 mW
Standby with WoCnml approx. 1 W
7.7.9 UMTS
UMTS functionality is provided by an u-blox LISA-U200 WCDMA and GPRS/EDGE module.
Changes and errors excepted. µCROS SL V1.10 EN - 2020/03 28