Upgrade Guide Owner manual

Page 4 of 8

[Note] If the computer you are using to upgrade is connected to the PBX through the

WAN port, you will need to ensure that Remote Upgrade is enabled under Networking-

>Administration->Administration

2. Click on Browse and find the current firmware file ip1000-<build#>.bin

3. Click on Start to Upgrade to begin the upgrade process

4. After the file is loaded, the PBX will reboot. When the reboot finished, unplug the power

for 15sec then reconnect the power

Initializing Storage

1. Log into the PBX and navigate to PBX Setup=>Services