Setup Manual

V1 mini series server instruction manual
- 6 -
ETH
Network interface
3. Notes
(1) In the process of running the server, please place it as shown in the picture below, that is, keep it flat
to avoid any damage to the server.
(2) The socket shall be installed near the server and shall be easily accessible.
(3) The two 6PIN power ports must be connected at the same time before the supplying power.
(4) This product requires a power input of 100~240VAC to make the product work normally. When the
server is powered off, the power switch must be turned off first.
(5) For your safety, it is forbidden to remove any screws on the server.
(6) Do not press the metal buttons on the casing.
III. V1 mini Classic WiFi: Use and Configuration
1. Server Connection
(1) Power Connection
The V1 mini Classic WiFi dedicated power supply has two 6PIN DC outputs, and the input of the power
supply is 100~240VAC. The server can work normally after confirming that the connection is good.