Installation Guide

PAGE 1

Undermount Stainless Steel Sink

Installation Instructions

Before You Start

• IPT Sink Company recommends that all undermount sinks be installed by an experienced, professional installer.

• IMPORTANT: The enclosed cutout template will create a countertop opening with a minimal (1/8” or less) reveal. It is

recommended that you discuss with your installer and agree that the nished appearance is the desired effect. IPT Sink Company is

not responsible for improper sink or countertop installations.

• IMPORTANT: The cabinet must be installed, secured, plumb, and level. Failure of this step can lead to product damage.

• IPT Sink Company undermount sinks should only be fastened to a solid surface countertop (i.e. granite, Corian® or Silestone®).

• IPT Sink Company is not responsible for sink or countertop if damaged during installation. Be sure to inspect the sink for damage

prior to beginning installation.

• Metal edges may be sharp – use caution when handling.

• Follow all local plumbing and building codes.

Recommended Tools & Materials (Not Included)

 Tape Measure

 Safety Glasses

 Painter’s Tape

 Level

 Framing Square

 Pencil (not permanent marker)

 Shims or Cabinet Fillers

 Denatured Alcohol

 Clamps

 Construction Adhesive

 Silicone Sealant

 Screws (recommended by countertop manufacturer)

50/50 Double Bowl Kitchen Sink 60/40 Double Bowl Kitchen Sink

D-Shaped Single Bowl Kitchen Sink Single Bowl Vanity Sink

PAGE 1
Undermount Stainless Steel Sink Installation Instructions 50/50 Double Bowl Kitchen Sink 60/40 Double Bowl Kitchen Sink D-Shaped Single Bowl Kitchen Sink Single Bowl Vanity Sink Before You Start • IPT Sink Company recommends that all undermount sinks be installed by an experienced, professional installer. • IMPORTANT: The enclosed cutout template will create a countertop opening with a minimal (1/8” or less) reveal.
PAGE 2
Undermount Stainless Steel Sink Installation Instructions 1. Position the template (provided with your sink) front to rear so the sink will not interfere with the cabinet; secure with tape. 1: Prep Countertop 2. Trace the template and remove. Dry fit the sink to verify the measurements. 3. Following the countertop manufacturer’s instructions, carefully cut the countertop on the inside of the traced line. 4. Locate and drill the mounting holes, following the countertop manufacturer’s instructions.
PAGE 3
Limited Lifetime Sink Warranty This product has been manufactured and tested to the highest quality standards by IPT Sink Company. We offer our customers thoughtfully crafted fixtures & accessories, engineered for enduring performance over years of use. WHO IS COVERED BY THE WARRANTY This warranty extends to the original purchaser only. This warranty is not transferable, between homes or owners and is only applicable to residential use.