Installation Guide
10
Open the screw cover with a
at blade screwdriver, then
loosen the screw using a
crosshead screwdriver.
1
83.50mm
Mounting screws
Wall mounting plate.
Holes drilled in wall.
Please use the specied batteries only.
Do not mix new and used batteries
CAUTION
Installing the Camera Door Unit
1) Remove the main unit from the mounting base
4) Adjust the camera lens angle
• The camera lens is adjustable to a maximum of 15 degrees.
• Please note that the video image may become slightly distorted if the camera
angle is set to maximum upper left/right adjustment.
Lift to remove the main unit
from the mounting base.
2
2) Fix the mounting base on the wall at the height and location selected
3) Install the batteries
Insert 6 x AA alkaline batteries.
Please ensure to observe the
correct +/- polarity as shown.
BATTERY STATEMENT
AA alkaline batteries do not perform well in very
cold temperatures. If you live in a cold climate
you may want to replace the alkaline batteries in
the Door Camera unit with AA Lithium batteries.