Installation Guide

11
Angle
adjustment
lever
Adjust camera
view to the left
(max. 15deg.)
Examples of possible camera adjustment
Camera looks
upwards
Adjust camera
view to the right
(max. 15deg.)
Adjust camera
view upwards
(Max. 15deg.)
Camera looks
to the right
Camera looks
up & right
5) Re-t the main unit to the mounting base
• Ensure to secure with the screw and replace the screw cover.
Power supply wires
6) Optional ways of powering the camera door unit
The Camera Door unit can be used without batteries by connecting it directly to the
existing 12V−16V wired doorbell supply or to a 12V−16V external power pack (not
supplied).
Remove the main
unit from the
mounting base.
1
Pass the bell wire or the wire
from the power pack through the
mounting plate before xing the
plate to the wall. Connect the wire
to the supply terminals directly.
2
Re-t the main unit
to the mounting
base and secure
with the screw.
3
Power supply wires
Power supply wires
If using an external 12V−16V power pack, it may
be necessary to cut off the attached connector in
order to connect the bare supply wires directly into
the terminals as described in (2) above.
4
A) Powering with an External Power Pack