Installation Guide

I. Opening and Closing the Air Cleaner Housing

Replacing Your HyperHEPA® Filter

The stacked housing elements are held together by two locking arms that hook into the

diffuser. To open the system, follow the steps below.

1. Disconnect the IQAir System from the power supply before at temp ting to open the system.

2. Press the rst locking arm outward, using both thumbs as shown. Press just hard enough to

release the arm from its snap-in position in the diffuser. Disengage the other arm in the same

way.

3. Pull both locking arms evenly outwards until they snap into place and remain open. Access

to all lters is now possible (to change the HEPA lter, refer to section II below).

4. To close the housing, simply align the housing modules and push the locking arms inwards

simultaneously until they snap back into the diffuser.

Opening Closing

Troubleshooting when closing the Housing

If the IQAir System does not close properly, the upper part of the system may

be offset against the lower part. To solve this problem, simply open both

locking arms again, align the housing modules and push both locking arms

in simultaneously.

II. Replacing the HyperHEPA® Filter (F3)

0209/105.01.10.31

1. Open the locking arms, making

sure they are fully extended

outward. For details, refer to the

section I.

2. Opening the arms will release the

top housing modules. Removing

the dif fu ser will reveal the Hyper-

HEPA lter inside Frame 3.

3. Remove Frame 3 containing the

Hyper HEPA l ter.

Frame 3

HyperHEPA®

lter

Frame 3

Diffuser

PAGE 1
Replacing Your HyperHEPA® Filter I. Opening and Closing the Air Cleaner Housing The stacked housing elements are held together by two locking arms that hook into the diffuser. To open the system, follow the steps below. 1. Disconnect the IQAir System from the power supply before attempting to open the system. 2. Press the first locking arm outward, using both thumbs as shown. Press just hard enough to release the arm from its snap-in position in the diffuser. Disengage the other arm in the same way. 3.
PAGE 2
4. Turn the frame upside down. 5. With the palm of the hand, press down on the filter and loosen the frame. 6. Lift the frame from the filter. Dispose of the used filter by placing it into the plastic bag in which the new filter is supplied.* Frame 3 7. Turn the frame over to its upright position and insert the new filter. 8. Ensure that the arrows on the filter label point upward, and the label “This way up” is visible on top of the filter. 9.