Installation Guide

The stacked housing elements are held together by two locking arms that hook into the

diffuser.To open the system follow the steps below.

1. Disconnect the device from the power supply before attempting to open the system.

2. Press the first locking arm outward, using both thumbs as shown. Press just hard

enough to release the arm from its snap-in position in the diffuser.Disengage the other

arm in the same way.

3. Pull both locking arms evenly outwards until they snap into place and remain open.

Access to all filters is now possible (to change a specific filter, refer to the appropriate

section below).

4. To close the housing, simply push the locking arms inwards simultaneously until they

snap back into the housing and the diffuser.

Old filters can normally be put in the regular trash for disposal. Only when the air cleaner has been exposed to

regulated substances may these filters need to be disposed of as hazardous waste.Please refer to local regulations and laws.

Swiss Made

1. Opening and Closing the Air Cleaner Housing

Replacing YourV5-Cell (Filter 2)

Opening

Closing

Troubleshooting when closing the housing

If the device does not close properly,the upper part of the system may be offset

against the lower part.

To solve this problem, simply open both locking arms again, align the housing

and push both locking arms in simultaneously.

0707/105010030

PAGE 1
Replacing Your V5-Cell (Filter 2) 1. Opening and Closing the Air Cleaner Housing Swiss Made 1. Disconnect the device from the power supply before attempting to open the system. 2. Press the first locking arm outward, using both thumbs as shown. Press just hard enough to release the arm from its snap-in position in the diffuser. Disengage the other arm in the same way. 3. Pull both locking arms evenly outwards until they snap into place and remain open.
PAGE 2
. Replacing the V5-Cell (Filter 2) Diffuser 1. Open the locking arms, making sure they are fully extended outward. Frame 3 V5-Cell Frame 2 Frame 2 2. Opening the arms will release the top housing modules. Remove the diffuser, then Frame 3 and put these to the side. 3. Frame 2 contains the V5-Cell (Filter 2). Diffuser Frame 3 Frame 2 4. Remove the old V5-Cell Filter lifting it out of the frame. Dispose of the old filter. * 5. Insert the new filter.