Installation Guide

ManualsBrandsIQAir ManualsAir Purifier AccessoriesHealthPro Series V5-Cell Gas and Odor Filter

3. Resetting the New Filter Menu

1. To reach the New Filter Menu from the main display window, press the

Menu key seven times.

2. Press and hold down the Enter key until the flashing filter appears (Filter 2

or V5-Cell). Press the arrow key  until the flashing V5-Cell (Filter 2) appears.

3. Press the Enter key to confirm that V5-Cell (Filter 2) has been replaced

(E=Yes). To safeguard against inadvertently resetting the life of the wrong

filter, you will be prompted to reconfirm your selection.The filter life LED for

the appropriate filter is now flashing red.

Note: If the wrong filter has been selected, or if you wish to exit the enter

mode, simply press the Menu key (M=Cancel).This will leave the filter life

controller unaffected.

4. To confirm the filter change and exit the New Filter Menu, press the Enter

key.The filter life LED for the V5-Cell (F2) is now reset from red to green.

The New Filter Menu allows you to reset the filter life counter for a newly replaced filter. As a result, the appropriate filter

life LED on the control panel will be reset to green and the hour count in the Remaining Filter Life Menu will be reset to the

full life span of the new filter.

5. To check the life span of the newly installed filter after having reset the

control panel, simply go to the Remaining Filter Life Menu and select the

appropriate filter number. (Please note that the reset remaining ﬁlter life

may vary from model to model.)

Resetting the filter life counter will also make the“Replace Filter” warning

disappear from the main display window.

2. Replacing the V5-Cell (Filter 2)

V5-Cell

Frame 2

1. Open the locking arms, making sure

they are fully extended outward.

2. Opening the arms will release the top

housing modules. Remove the diffuser,

then Frame 3 and put these to the side.

3. Frame 2 contains the V5-Cell (Filter 2).

5. Insert the new filter.Ensure that the ar-

rows on the filter label point upward.

4. Remove the old V5-Cell Filter lifting

it out of the frame. Dispose of the old

filter. *

Frame 3

rame 2

iffuser

6. Put Frame 2 back onto the housing,

followed by Frame 3 and the diffuser.

For closing refer to section I.

Diffuser

rame 2

Frame 3

* If harmful substances are filtered,disposal of the used filters may be subject to local regulations or laws.

