Instructions / Assembly

Installation Instructions for Filter Cartridges

of GC, GCX and Dental Series Air Puriﬁers

Before the cartridges are unpacked from their individual wrapping,

it is recommended that working surfaces are covered because

loose carbon granuals may soil surfaces. Once unpacked, place the

cartridges on the table/ﬂoor with the opening facing downward

and pull a post-ﬁlter sleeve over each of the cartridges. With new

IQAir systems the sleeves are supplied inside of the IQAir System

(refer to steps 3, 4 and 5 below on how to open the IQAir System).

Cartridge shown with sleeve ﬁtted. Ensure cartridge is completely

covered by post-ﬁlter sleeve.

105 03 00 22 / 1109

Pull the ﬁrst locking arm outward to release the arm from its snap-

in position in the diffuser. Disengage the other arm the same way.

Pull both locking arms outwards evenly until they snap into place

and remain open.

Remove the diffuser and one top (GCX: top three) housing element.

If used cartridges are being replaced, also remove the frame element

containing the cartridges. Remove each cartridge by turning it

counterclockwise.

The slots on the metal plate should look as shown in the large

picture above.

Note: If you have an older IQAir system, the slot may look different

(see small picture above). In that case a set of cartridge adapter

rings is required to enable the insertion of new-style cartridges into

your IQAir system. These adapter rings can be obtained from your

point of purchase.

New-style slot

Old-style slots

(requires adapter ring)

PAGE 1
Installation Instructions for Filter Cartridges of GC, GCX and Dental Series Air Purifiers 1 2 Cartridge shown with sleeve fitted. Ensure cartridge is completely covered by post-filter sleeve. Before the cartridges are unpacked from their individual wrapping, it is recommended that working surfaces are covered because loose carbon granuals may soil surfaces. Once unpacked, place the cartridges on the table/floor with the opening facing downward and pull a post-filter sleeve over each of the cartridges.
PAGE 2
7 th T w e c op ith ar o ha trid f nd ge le 8 Once placed into the slots, turn the cartridge clockwise until it is securely locked onto the plate. Repeat with the remaining cartridges. 9 Refit the housing element containing the cartridges onto the IQAir system. 10 Replace the remaining housing element(s) and the diffuser. Close the two locking arms simultaneously until they securely lock into the diffuser.