Installation Manual

10
Removing the mounting plate
Loosen the hex socket screw with the supplied Allen key until the mounting plate can be
released form the device. There is no need to remove the screw completely.
Only in case you need to insert a USB 4G modem or replace an air quality sensor module,
the mounting plate and air inlet cover needs to be removed from the IQAir AirVisual Outdoor.
Remove the mounting screw
Remove the mounting plate
Slide off the air inlet cover
Mounting the device
To ensure the device is installed properly, you must follow the IQAir recommendations and
considerations.
Use the supplied mounting hardware
(wall anchors and screws or cable ties).
Check if the air inlet cover is attached.
Slot the device into the mounting hook.
Push the device gently into the mounting plate.
Tighten the hex socket screw until snug.