Manual and Installation Guide

Series GA201M2 Page 14 Sept 25, 2020
Installation Instructions
Connecting the LP-Gas Supply
1. Lift the Main Housing Cover up by the handles until the bottom lip is clear of the 3 spring latchs as
shown below.
2. Secure the LP-Gas Cylinder to the Base using the Bungee cord. Hook one side of the Bungge to the
mounting holes on either the right side of left as shown below. Make sure the LP-Gas cylinder is in the
upright position. Feed Bungee through the handle of the LP cylinder, then hook the Bungge on the other set
of securing holes.