Manual and Installation Guide

Series GA201M2 Page 15 Sept 25, 2020
Installation Instructions
3. Locate the regulator assembly. Look over the assembly to make sure no damage has occurred during
shipping of handling. Attach the regulator assembly to the male quick connect on the fuel supply hose as
shown below.
4. Secure the Gas Hose Regulator onto the LP-Gas Cylinder valve by turning the Regulator clockwise until
tight. Push the 3 spring latches that are holding the Main Housing Cover in place inwards, one hand holding
the bottom lip of the Main Housing Cover and one pushing the latches one at a time. Be careful of the
bottom edge of the Main Housing as it is sharp.
Before using the patio heater:
• Perform a leak test to make sure Regulator connection does not have leaks..
• Move Heater to desired location.
• Secure the Base Body to the floor.