Manual and Installation Guide

Series GA201M2 Page 16 Sept 25, 2020
Installation Instructions
Position / Move the Heater
1. Ensure the LP-Gas Cylinder is turned OFF, secured and disconnected from the Gas Hose prior to
moving the Heater.
2. Ensure Wheels are properly connected to the Base Body. (Refer to Installation Step 10.)
3. Move the Heater by handling ONLY the Pole or the Base Body. It may take two people to
manoeuvre the Heater safely depending on the size / strength of the person(s).
4. Tip the Heater backwards at an angle to / overtop of the wheels until Base no longer touches the
ground. Wheel / roll Heater to the desired new location and return Base to ground. Ensure Heater
is on level ground and stable in new location.
5. If the Heater is going to be operated at the new location, the “Testing / Commissioning
6. ” procedure must be completed
.